|
MATERIAL SAFETY
DATA SHEET General
Manufacturers
Name: Slickote Coatings
Date Prepared: 2/23/01
Street Address: 244
E. Pomona Ave.
Monrovia CA 91016
Emergency No: 1-
800-424-9300
Information:
626-358-1151
Product Class:
Solid Film Lubricant
V.O.C.: < 1.1 Lbs/Gal (135 g/l)
Product Name:
Slickote M1 / MIL-PRF-46147C Ty 1&2
INGREDIENTS/ IDENTITY INFORMATION
Acetone
CAS#
67-64-1
NIOSH (RTECS) AL3150000
OSHA PEL:
1000 ppm
ACGIH TLV
750 ppm
P-Chlorobenzotrifluoride
CAS#
98-56-6
NIOSH (RTECS) XS914500
OSHA PEL:
not established
ACGIH TLV
not established
Molybdenum Disulfide
CAS#
1317-33-5
NIOSH (RTECS) QA4697000
OSHA PEL:
10 MG MO/M3 (as powder)
ACGIH TLV
10 MG MO/M3 (as powder)
Percent
<14%
____________________________________________________________________________________________
Antimony Trioxide
CAS#
1309-64-4
NIOSH (RTECS) CC5650000
ACGIH TLV
0.5 MG/ CUM
Percent
<4%
____________________________________________________________________________________________
Methyl n-Propyl Ketone
CAS#
107-87-9
NIOSH (RTECS) SA7875000
OSHA PEL:
200 ppm
ACGIH TLV
200 ppm
Xylene
(SARA III)
CAS#
1330-20-7
NIOSH (RTECS) ZE2100000
OSHA PEL:
100 ppm/ 150 STEL
ACGIH TLV
100 ppm/ 150 STEL
Percent
<1%
PHYSICAL
CHEMICAL CHARACTERISTICS
Physical Form
: Liquid
Color
: Grey/ Black
Odor
: Slight Solvent
pH
: n/a
Boiling Point
: Approx. 133 deg F (Acetone)
Melting/Freezing Point : n/k
Solubility in Water
: not soluable
Specific Gravity
: 1.19
Bulk Density
: 9.96 Lbs/gal
% Volatile by Weight
: 74%
to 75%
Vapor Pressure
: 184 mm/Hg (Acetone)
FIRE
& EXPLOSION HAZARD DATA
Flash Point
: -15 deg F (Acetone)
Flammable Limits:
Upper
Explosive Limit (UEL) (%) : 13.0%
(Acetone)
Lower
Explosive Limit (LEL) (%) : 2.0%
(Acetone)
Auto-Ignition Temperature :
no data
Extinguishing Media
: Dry Chemical; Carbon Dioxide; Form; Water
Special Fire Fighting Procedures
: Full emergency equipment with self-contained breathing apparatus and
full protective clothing should be worn by firefighters.
During a fire, irritating, highly toxic gases may be generated by thermal
decomposition or combustion.
Unusual Fire / Explosion Hazards : Isolate from heat,
electrical equipment, sparks and open flame. Closed container may explode when contaminated with water
(CO2 evolved). Solvent vapors may
be heavier than air.
Stagnant air may cause vapors to build up and travel
along the ground to an ignition source which may result in a flash back to the
source of the vapors
REACTIVITY
DATA
This product is stable.
Conditions to avoid: strong oxidizers
Incompatibility: Coagulation may occur following
freezing, thawing or boiling.
Hazards polymerization: None
HEALTH
HAZARD DATA
Acute
Hazard: Burning, tearing, drying or cracking of skin, coughing, chest pain,
difficulty in breathing, nausea, vomiting, abdominal discomfort, diarrhea.
Medical conditions generally aggravated by exposure-any respiratory or skin
condition
Possible
routes of entry: inhalation, ingestion, skin absorption
Emergency
and first aid procedures: Eyes: Flush with water for 15 minutes. Skin: Wash with
soap and water, not with solvents. Inhalation: Remove to fresh air from exposure
area., give CPR if necessary. Ingestion: Do not induce vomiting. In all cases,
obtain immediate medical attention.
Carcinogenicity:
NTP: No
IARC: No
OSHA: No
(Antimony Trioxide
–suspected animal carcinogen by ACGIH)
Calif
Prop 65 –Yes (Antimony Trioxide)
HMIS:
Health: 2
Flammability: 3 Reactivity: 0
PRECAUTIONS
FOR SAFE HANDLING AND USE
Precautions to be taken in handling storage:
Keep
containers closed when not in use. Do
not store above (115 deg. F ) keep from freezing. Empty containers may contain
product residue. Do not cut,
puncture or weld containers. All
label warning must be observed, until container has been cleaned or
reconditioned, or properly disposed of. Mix
material well to proper specifications.
Spills:
Wear air supplied NIOSH approved respirator for major unventilated release.
Cover with absorbent material and keep loosely covered for 48 hours. Clean up
residue with water.
CONTROL
MEASURES
Ventilate area; remove spills with inert absorbent.
Waste disposal method: Dispose in chemical disposal
area or in a manner that complies with local state and federal regulations, do
not incinerate closed containers.
Use protective gloves, chemical splash safety
glasses, and protective resistant apron.
DOT ID#: UN1263
DOT proper shipping name: Paint or Paint Related
Material
DOT Label: Flammable
Liquid
DOT Class : 3
| 
